Products

TXMAS

Boiler Tube Fabrication

Boiler Tubes of Texas

Boiler Tubes of Texas

Supplying Straight and Bent tubing for all your Boiler needs.

During our 35 years in the fabrication business we have accumulated a large inventory of tooling and have produced tubes for almost every boiler make and model ever manufactured. Bent tubes are an integral component of boiler design and operation, so our shop is equipped with several bending machines to serve you quickly and effectively. You may supply either blue prints or a pattern tube that has been removed from the boiler. When necessary we can visit your site and take the measurements we need to fabricate your tubes. Our experienced personnel maintain a constant uniform tube wall thickness using a mandrel, so you can be sure that tube bending, like all of our other services is carried out with the utmost precision. Call us the next time you're in the market for tubes, whether you require a large or small quantity.

Boiler Tubes of Texas
1956 Singleton Blvd.
Dallas, TX 75212

Phone: 214-637-0020 ext. 356
Fax: 214-637-4612

A division of Holman Boiler Works Inc.

Learn more about our tube fabrication capabilities:

Superheaters

Tubes Super Heater

Split and Wiper dies for tight radius bending.
We have many years experience with convective and radiant superheaters, so we have the expertise to assemble a vast assortment of quality superheaters. Our experience combined with our inventory of tooling allow us to furnish all your needs, from tubes ready for assembly to the complete unit ready to install.

Heat Exchangers

Tube Bending

Bend copper, stainless or mild steel. 50 dies ranging from 3/4" to 15 1/2."
We have a full range of tooling and experienced personnel to provide your heat exchanger needs. Our bending capabilities include 3/4", 1" & 1 1/2 " OD tubes and radius sizes range from 3/4' to 15 1/2". We have worked with a variety of materials including copper, stainless and mild steel. give us the opportunity to provide you with your next set of tubes or a complete bundle ready to install.

Fin Welding

Tube Finning

Two automatic fin welders - submerged arc.
50% tube penetration and 100% to the fins 2" to 3" OD with 1/2" to 1 1/2" fin.

In order to increase boiler efficiency, engineers currently design and market boiler with finned tubes. These tubes form a gas-tight envelope that prohibits gases from escaping the furnace and convection sections; however, relatively few finned tube-welding machines are in use at this time. To serve our customers with this process, we installed several fin tube-welding machines so we can flat fin a wide variety of tubes. Call on Boiler Tubes of Texas for replacement of finned tubes, initial installation or conversion of your existing boiler.

Swage Tubes

Tube Swageing

Dies for 1 1/4" to 3 1/4" OD / Walls .095 to .250mw.
Max of 13" Swage or reduced length. Capable of maintaining wall thickness.

Tube wall thickness is a critical factor for safe, efficient boiler operation. We have the unique ability to reduce the diameter of a tremendous variety of tubes sizes without compromising the tube wall thickness. Our swaged tube machine promises uniform tube thickness and is another fine example of our continued efforts to provide customers with excellent quality service.

Quality Control

Tube Layout

Quality is maintained through the tube fabricating process. Tubes are continuously checked for angle of bend, quality and dimensional stability. Tubes can be fabricated to Holman's "Tube Bend Standards" or customer specifications.


Holman Boiler Works has twelve locations serving Texas, the Southwest, and the Midwest:
Dallas / Fort WorthHoustonCorpus ChristiSan Antonio / Austin McAllen
St LouisIowaKansasNebraskaChicagoBloomingtonGeneseo